Transmission sprocket

Having been a lot more than 20 years in the market , we continue steadily to improve our goods/quality and services among the market leaders today.
Why Ever-power?
Carburized Bushing
Carburizing process increases surface area hardness and wear resistance, while the core remains troublesome and ductile.
Shot Peening to All Components
All Omega’s conveyor chain parts are very well shot peened, to be able to increase component life.
Ultimate Material Specification
New materials specification with better strength in chain breaking load, yet is still the most cost-effective decision.
Professional Technical and Merchandise Support
Supported by experienced crew and recognized branches in strategic places throughout China
Transmission Sprocket Installation
1. Install the transmitting sprocket (with belt) on the key drive gear. 2. Install the sprocket nut. The next procedure is based on whether a new or used nut is being installed. Note: The Tranny Sprocket nut has still left handed threads. Flip the nut counterclockwise to install on the main drive gear. Sprocket Nut: apply crimson thread lock to the threads of the sprocket nut. Likewise smear a small quantity of reddish thread lock or clean engine essential oil on the inside deal with of the sprocket nut and the exterior deal with of the sprocket. Limit the application to where in fact the surfaces of both parts contact one another. Install the sprocket nut until finger restricted. 3. Obtain Last Drive Sprocket Locking Instrument (BAKER P/N: Tool-C) to lock transmitting sprocket. Proceed as follows: A. Insert take care of of instrument below pivot shaft inboard of bottom level frame tube and put on sprocket. B. Snug thumbscrew to lock job of software on sprocket. 4. Obtain Mainshaft Locknut Wrench/Pilot (BAKER P/N: Tool-D). Proceed as follows: A. Install pilot on threaded end of mainshaft. B. Slide sleeve of locknut wrench over pilot and onto sprocket nut. C. Tighten sprocket nut to 60 ft-lbs. (81 Nm). As the nut is certainly tightened the deal with of the sprocket locking tool rises to contact the pivot shaft, thus preventing sprocket/mainshaft rotation. 5. Scribe a straight line on the transmitting sprocket nut continuing the collection over onto the transmitting sprocket. Tighten the transmitting sprocket nut yet another 35 to 40 degrees. 6. Install lockplate over nut to ensure that the two diagonally contrary holes align with two tapped holes in sprocket. To find the best suit, lockplate could be rotated to several positions and will be put with either aspect facing sprocket. 7. If holes in lockplate do not align with those in sprocket, tighten sprocket nut as important (up to 45 degrees optimum) until sprocket and lockplate holes happen to be in alignment.

V-FACTOR
24 Tooth Sprocket Kit
Fits Big Twin 4 speed with rear disc

If you have any type of questions concerning Transmission Sprocket call us on our website