Electrical power UNITS FOR LIFT TABLE one
Standard Description
This electrical power unit is built solely for your modest lift table,Consisting of high strain gear pump, AC motor, multi-functional manifold, valves, tank, and so on. This electrical power unit has become broadly applied within the marketplace of logistic 
gadgets such as minifork lift, scissors lift and ariel doing work platforms. The lower-ing motion is controlled through the solenoid valve together with the speed controlled through the adjustable needle valve.
Electrical power UNITS FOR LIFT TABLE two
Common Description
This electrical power unit is developed solely for that medium lift table, Consisting of very effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The decreasing motion is actived from the solenoid valve and the velocity managed through the adjustable needle valve. When the lift rises to a high positoin, but the electrical power supply is reduce, the reducing motion is managed through the manual override function.
Energy UNITS FOR LIFT TABLE three
Basic Description
This power unit is made solely for your substantial lift table, Consisting of hugely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing motion is actived by the solenoid valve and the speed controlled by a strain compensated movement management valve.
Energy UNITS FOR LIFT TABLE four
Basic Description
This power unit is designed exclusively for the massive lift table, Consisting of remarkably effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing movement is actived through the solenoid valve and the pace managed by the adjustable needle valve. When the lift rises to a large positoin, but the electrical power supply is minimize, the decreasing movement is managed from the manual override perform.
Special Notes
one. This electrical power unit is of S3 duty cycle, which may only do the job intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
2. Clean each of the hydraulic elements concerned ahead of installation of the electrical power unit.
three. Viscosity in the oil shoud be 15~46 cst,which really should also be clean and free of impurities.N46 hydraulic oil is suggested.
four. Oil modifying is needed after the initial one hundred operation hrs,afterwards as soon as every single 3000 hrs.
five. The electrical power unit shown is created to be mounted vertically.
